Hello all,

Firstly may I thank all for the info on this Brilliant community for the information I have read about in the past.

I have a little dilema on my hands, I wish to cut down on the amount of equipment that I use but retain the sound quality, I have a set of Bass bins and obviosly Top End but at the moment I run them from different amps in mono !

Is there a gizmo that I could fit to the bass end so i could plug the top end into cutting down on an amp and an Eq and leads, and getting stereo from all four speakers ????

I've tried looking but end up getting lost ???

Cheers All

Dave

Hang on.

So you have four speakers and two amps?

If you could tell us what speakers and amps you use, that would be great.

What I would do (assuming there are 2 bass bins and 2 top's) is this:

1) Mixer into Graphic (and limiter?)

2) Output of graphic/limiter into one amp for bass bins

3) Another output of the graphic/limiter into another amp into the tops (all in stereo)

This way, if one amp goes, there will always be sound

More info needed on this one though and you may be looking at a crossover which spilts all the sounds to the correct speakers..